Продукция Mapei (Aquatus) Gold`s Gym & Dilijan International school (Aquatus) Офис фирмы Акватус Полиуретановые полы Mapei (Aquatus) Tiles for swimming pool (Aquatus) Ultratop Loft (Aquatus) Лампа из гималайской соли Harvia (Aquatus)

Cleaning the filter

Approximately every 5-10 days, or if the pressure gauge on the discharge side of the filter shows an increase in pressure of about 0.2 bar (20 kPa) compared with previous readings after washing, the filter must be washed according to the following scheme:

Modes backwash valve

1. Stop the pump.
2. Close the valve on the suction and return lines.
3. Open the pump and clean the basket.
4. Close the cover.
5. Open the drain valve to the output.
6. Turn the knob to the backwash (BACKWASH).
7. Open the valve on the suction and return lines.
8. Start the pump. The filter should be washed with a jet of approximately 1-2 minutes or until the water in the sight glass is transparent.
CAUTION! The electric heater must be disabled.
9. Turn off the pump.
10. Turn the lever to RINSE (RINSE), start the pump and let it run for about 15-30 seconds. Then stop the pump and turn the knob to the FILTER (FILTER), which is the normal operating position of the filter.
11. Close the drain outlet valve and start the pump. Switch on the electrical heater.

FILTRATION

The normal position of the filter

BACKWASH

Cleaning the filter sand

RINSE

Stabilizing the filter sand

WASTE

The situation at the bottom of the vacuum processing directly into the drain, or when emptying the pool

CLOSED

Closed

RECIRCULATION

Pumping water into the pool directly (without filtration)

Filter-cleaning-eng Aquatus

All Right Recevied © 2000-2017 Aquatus Frontier Theme